Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING › 2011.12–2015.11
RM2170E _59 Vehicle Exterior _057051 EXTERIOR PANELS / TRIM _0278212 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 68230C 1.INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

a.
B298002

Engage the guide and 4 claws to install the rear door glass outer weatherstrip assembly.


Hide 68104 2.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67408E 3.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 68152C 4.INSTALL REAR DOOR GLASS RUN

Hide 67842E 6.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67604 7.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 8.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 67674A 9.INSTALL REAR DOOR FRAME GARNISH

Hide 10.CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).