45047
1.INSTALL TIE ROD END SUB-ASSEMBLY LH
| *a | Matchmark |
Install the lock nut and tie rod end sub-assembly LH to the steering gear assembly until the matchmarks are aligned.
After adjusting the toe-in, tighten the lock nut.
45046
2.INSTALL TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
3.INSTALL STEERING LINK ASSEMBLY
Install the steering link assembly to the front suspension crossmember sub-assembly with the 2 bolts and 2 nuts.
Keep the nut from rotating while turning the bolt because the nut has its own stopper.
Make sure to tighten the bolts starting from the right side of the vehicle.
45025D
4.INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Install the No. 1 steering column hole cover sub-assembly to the steering link assembly.
51201
5.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Support the front suspension crossmember sub-assembly with an engine lifter using 4 attachments or equivalent tools.
Make sure to secure the front suspension crossmember sub-assembly to prevent it from dropping.
Use the attachments to keep the front suspension crossmember sub-assembly level.
The front suspension crossmember sub-assembly is a heavy component. Make sure that it is supported securely.
Temporarily tighten the front suspension crossmember sub-assembly to the vehicle body with the 6 bolts.
Tighten the 2 bolts (A), 2 bolts (B) and 2 bolts (C) on the left and right sides while alternately inserting SST into the left and right side reference holes in the front suspension crossmember sub-assembly.
| *a | OK | *b | NG |
|
Front of the Vehicle | - | - |
Lower the engine lifter.
Install the engine moving control rod with the bolt.
48069
6.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
48068
7.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
45047
8.CONNECT TIE ROD END SUB-ASSEMBLY LH
Connect the tie rod end sub-assembly LH to the steering knuckle with a new nut.
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
Install a new cotter pin.
45046
9.CONNECT TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
48810
10.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
48820B
11.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as for the LH side.
45025D
12.CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
| *a | Lip |
Place clip (A) as shown in the illustration and engage clip (B) to the vehicle body to connect the No. 1 steering column hole cover sub-assembly.
Make sure that the lip of the No. 1 steering column hole cover sub-assembly is not damaged.
45209
13.CONNECT STEERING SLIDING YOKE SUB-ASSEMBLY
45259A
14.INSTALL COLUMN HOLE COVER SILENCER SHEET
15.INSTALL FRONT WHEELS
16. POSITION WHEELS FACING STRAIGHT AHEAD
17. STABILIZE SUSPENSION
18.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (Integrated Cover Type)
19.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT