12363A
1.INSTALL ENGINE MOVING CONTROL ROD
Install the engine moving control rod to the front suspension crossmember sub-assembly with the bolt.
48069
2.TEMPORARILY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Temporarily tighten the front lower No. 1 suspension arm sub-assembly LH to the front suspension crossmember sub-assembly with the bolt.
48068
3.TEMPORARILY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
48811
4.INSTALL FRONT STABILIZER BAR
48829A
5.INSTALL FRONT NO. 1 STABILIZER BRACKET LH
48824A
6.INSTALL FRONT NO. 1 STABILIZER BRACKET RH
Perform the same procedure as the LH side.
7.INSTALL STEERING LINK ASSEMBLY
51201
8.INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Support the front suspension crossmember sub-assembly with an engine lifter using 4 attachments or equivalent tools.
Make sure to secure the front suspension crossmember sub-assembly to prevent it from dropping.
Use the attachments to keep the front suspension crossmember sub-assembly level.
The front suspension crossmember sub-assembly is a heavy component. Make sure that it is supported securely.
Temporarily tighten the front suspension crossmember sub-assembly to the body with the 6 bolts.
Tighten the 2 bolts (A) and 2 bolts (C) on the left and right sides while alternately inserting SST into the left and right side reference holes in the front suspension crossmember sub-assembly.
| *a | OK | *b | NG |
|
Front of the Vehicle | - | - |
Do not tighten bolt (B) to the specified torque. Bolt (B) will be fully tightened after the suspension is stabilized.
Lower the engine lifter.
Install the engine moving control rod with the bolt.
48069
9.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
48068
10.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
45047
11.CONNECT TIE ROD END SUB-ASSEMBLY LH
45046
12.CONNECT TIE ROD END SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
48810
13.INSTALL FRONT STABILIZER LINK ASSEMBLY LH
Install the front stabilizer link assembly LH to the front stabilizer bar with the nut.
Use a hexagon socket wrench to hold the stud.
48820B
14.INSTALL FRONT STABILIZER LINK ASSEMBLY RH
Perform the same procedure as the LH side.
45025D
15.CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
45209
16.CONNECT STEERING SLIDING YOKE SUB-ASSEMBLY
45259A
17.INSTALL COLUMN HOLE COVER SILENCER SHEET
18.INSTALL FRONT WHEEL
19.STABILIZE SUSPENSION
Lower the vehicle.
Bounce the vehicle up and down several times to stabilize the suspension.
48069
20.FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
48068
21.FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Perform the same procedure as the LH side.
22.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (Integrated Cover Type)
23.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT