Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › ECM › from 2017.06
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277910 ECM A

1NZ-FXE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

If the ECM has been struck or dropped, replace it.

·

Perform Vehicle Identification Number (VIN) registration when replacing the ECM.

w/ Canister Pump Module: Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM(w/ Canister Pump Module)>REGISTRATION

w/o Canister Pump Module: Click hereEngine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>REGISTRATION



Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 89661 4.REMOVE ECM (for RHD)

a.
A267404

Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.



b.
A267405

Remove the bolt and nut.


c.

Remove the ECM.


d.
A267867

Remove the 4 screws, No. 1 ECU bracket and No. 2 ECU bracket.


Hide 5.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD)

Hide 55722C 6.REMOVE INNER COWL TOP TO COWL BRACE (for LHD)

Hide 55735B 7.REMOVE FRONT AIR SHUTTER SEAL (for LHD)

Hide 55815E 8.REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)

Hide 55701J 9.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

Hide 89661 10.REMOVE ECM (for LHD)

a.
A267430

Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.



b.
A267431

Remove the bolt and nut.


c.

Remove the ECM.


d.
A267428

Remove the nut.


e.
A267429

Remove the 4 screws, No. 1 ECU bracket and No. 2 ECU bracket.