1. PRECAUTION
G3834
2.REMOVE SERVICE PLUG GRIP
3.REMOVE REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback)
71033
4.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
G9223
5.REMOVE INVERTER TERMINAL COVER
G9221
6.REMOVE INVERTER COVER
7.CHECK TERMINAL VOLTAGE
G9221
8.INSTALL INVERTER COVER
G9223
9.INSTALL INVERTER TERMINAL COVER
899A0B
10.REMOVE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
G92F1
11.REMOVE NO. 1 HYBRID BATTERY EXHAUST DUCT
G92N1A
12.REMOVE NO. 1 HYBRID VEHICLE BATTERY COVER PANEL LH
Wear insulated gloves.
Using the service plug grip, remove the battery cover lock striker.
| *1 | Service Plug Grip |
| *2 | Battery Cover Lock Striker |
| *3 | Button |
| *a | Projection |
| *b | Turn |
Insert the projection part of the service plug grip, and turn the button of the battery cover lock striker counterclockwise, and release the lock.
Remove the 4 nuts and No. 1 hybrid vehicle battery cover panel LH.
82164
13.DISCONNECT FRAME WIRE
Wear insulated gloves.
Insulate the disconnected connectors with insulating tape.
Disconnect the 2 connectors shown in the illustration.
| *1 | Shielded Wire Ground |
Disconnect the shielded wire ground and frame wire.
G920R
14.REMOVE NO. 2 HYBRID BATTERY SHIELD SUB-ASSEMBLY
Wear insulated gloves.
Disconnect the connector.
Disconnect the connector and clamp.
Disconnect the 2 connectors and 3 clamps.
Remove the 2 bolts and 2 nuts.
Move the HV battery toward the front of the vehicle.
| *a | Front of Vehicle |
Move the HV battery to a position where both the No. 2 hybrid battery shield sub-assembly and the hybrid battery junction block assembly can be removed.
Remove the 2 bolts, nut and No. 2 hybrid battery shield sub-assembly.
G92Z0
15.REMOVE HYBRID BATTERY JUNCTION BLOCK ASSEMBLY
Wear insulated gloves.
Insulate the disconnected terminals with insulating tape.
Open the terminal cover.
Using an insulated tool, remove the 2 bolts.
Disconnect the connector.
Remove the 3 bolts and hybrid battery junction block assembly.