Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR AIRBAG SENSOR › from 2017.06
RM2170E _58 Vehicle Interior _057039 SUPPLEMENTAL RESTRAINT SYSTEMS _0278109 REAR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 89860C 1.INSTALL SIDE NO. 2 AIRBAG SENSOR ASSEMBLY

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

B296255E06
4.763,1.829 4.955,2.012 0.192,0.183 10 *b 1.4,1.829 1.592,2.012 0.192,0.183 10 *b 4.763,0.568 4.955,0.751 0.192,0.183 10 *a 1.4,0.568 1.592,0.751 0.192,0.183 10 *a

Text in Illustration
*a Incorrect *b Correct


d.

Insert the pin (stopper) into the body hole and install the side No. 2 airbag sensor assembly to the vehicle body with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the side No. 2 airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the side No. 2 airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

·

Make sure that the pin (stopper) is securely inserted into the body hole.

·

Tighten the bolt while holding the side No. 2 airbag sensor assembly because the side No. 2 airbag sensor assembly pin (stopper) is easily damaged.




e.

Connect the connector to the side No. 2 airbag sensor assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


i.

Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).

H103068E01
2.448,1.792 2.448,1.385 false 2.188,0.76 2.302,0.281 2.302,0.281 2.427,0.281 false 2.385,0.99 2.635,0.625 2.635,0.625 2.76,0.625 true 2.479,0.146 2.938,0.344 0.458,0.198 10 false (A) 2.813,0.542 3.271,0.74 0.458,0.198 10 false *1 2.375,1.833 2.833,2.031 0.458,0.198 10 false *2 6.01,3.427 6.469,3.625 0.458,0.198 10 false *a

Text in Illustration
*1 White Housing Lock *2 Yellow CPA
*a Connection is Completed - -

HINT:

When engaged, the white housing lock will slide. Be sure not to hold the white housing lock or part (A), as it may result in an insecure fit.




f.

Check that there is no looseness in the installation parts of the side No. 2 airbag sensor assembly.


Hide 64740C 2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY

Hide 81330 3.INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)

Hide 73370 4.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

Hide 64716D 5.INSTALL REAR DECK TRIM COVER (w/o Coat Hook)

Hide 64716D 6.INSTALL REAR DECK TRIM COVER (w/ Coat Hook)

Hide 64330D 7.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

Hide 64777J 8.INSTALL SPARE WHEEL CUSHION (w/ Coat Hook)

Hide 58570A 9.INSTALL REAR FLOOR MAT ASSEMBLY (w/ Coat Hook)

Hide 64997 10.INSTALL DECK FLOOR BOX LH (w/o Coat Hook)

Hide 64995 11.INSTALL DECK FLOOR BOX RH (w/o Coat Hook)

HINT:

Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).


Hide 58410B 12.INSTALL DECK BOARD ASSEMBLY (w/o Coat Hook)

Hide 62332A 13.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

Hide 67918A 14.INSTALL REAR DOOR SCUFF PLATE

Hide 15.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 58167H 18.INSTALL FRONT CENTER FLOOR COVER

Hide 71960B 21.INSTALL REAR CENTER SEAT HEADREST ASSEMBLY (for LH Side)

Hide 71940A 22.INSTALL REAR SEAT HEADREST ASSEMBLY