Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › from 2018.08
RM2170E _54 Brake _057021 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0278020 ELECTRONICALLY CONTROLLED BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


When troubleshooting a vehicle using the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the skid control ECU.

The skid control ECU records DTCs when it detects a malfunction in itself or in its circuits.

To check for DTCs, connect the GTS to the DLC3 on the vehicle. The GTS can be used to clear the DTCs, activate various actuators, and check the Freeze Frame Data and Data List.

a.

Check the auxiliary battery voltage.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge the auxiliary battery before proceeding to the next step.




DIAGNOSIS


a.

If the skid control ECU detects a malfunction, the ABS warning, brake warning / red (malfunction), brake warning / yellow (minor malfunction) and slip indicator lights will come on in order to warn the driver.


b.

The DTCs are simultaneously stored in memory.

The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights (w/o Occupant Classification System), or by connecting the GTS (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).


c.

This system has a Test Mode (signal check) function.

The DTCs can be read by connecting SST between terminals TS and CG of the DLC3 and observing the blinking pattern of the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights (w/o Occupant Classification System), or by connecting the GTS (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>TEST MODE PROCEDURE).



WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK


a.

When the power switch is turned on (IG), check that the ABS warning, brake warning / red (malfunction), brake warning / yellow (minor malfunction) and slip indicator lights come on until the power switch is turned on (ready).

HINT:
·

When the power switch is turned on (IG), the VSC OFF indicator light comes on for approximately 3 seconds.

·

When the brake fluid level is low, the brake warning light / red (malfunction) comes on.

·

If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS warning, brake warning / red (malfunction), brake warning / yellow (minor malfunction), VSC OFF indicator and slip indicator light circuits.

·

If an indicator remains on or does not come on, proceed to troubleshooting for the light circuits listed below.



Trouble Area See Procedure
ABS warning light circuit (Remains on) (Click here)
ABS warning light circuit (Does not come on) (Click here)
Brake warning light / red (malfunction) circuit (Remains on) (Click here)
Brake warning light / red (malfunction) circuit (Does not come on) (Click here)
Brake warning light / yellow (minor malfunction) circuit (Remains on) (Click here)
Brake warning light / yellow (minor malfunction) circuit (Does not come on) (Click here)
VSC OFF indicator light circuit (Remains on) (Click here)
VSC OFF indicator light circuit (Does not come on) (Click here)
Slip indicator light circuit (Remains on) (Click here)
Slip indicator light circuit (Does not come on) (Click here)