DTC CHECK/CLEAR (When Using the GTS)
Check for DTCs.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Read the DTCs following the prompts on the GTS screen. Enter the following menus: Chassis / ABS/VSC/TRC / DTC.
Check the details of the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
Clear the DTCs.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / DTC / Clear.
DTC CHECK/CLEAR (When not Using the GTS) (w/o Occupant Classification System)
Check for DTCs.
Using SST, connect terminals TC and CG of the DLC3.
| *a | Front view of DLC3 |
Turn the power switch on (IG).
Observe the blinking pattern of the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights in order to identify the DTC.
If no code appears, inspect the TC and CG terminal circuit, and ABS warning, brake warning / yellow (minor malfunction) and slip indicator light circuits.
Count the number of blinks of the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights.
How to read DTCs:
Diagnostic trouble codes are represented by the number of blinks of a warning light. For example, code 21 would be shown by 2 blinks, a pause of 1.5 seconds, and then 1 blink.
If one code is detected:
The light repeats the same code after a pause of 4 seconds.
If multiple codes are detected:
The light outputs one code after another with a 2.5-second pause between each code. When all codes have been output, there is a 4-second pause and then the light begins to output the codes again.
Check the details of the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
After completing the check, disconnect terminals TC and CG of the DLC3 to turn off the display.
If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.
Clear the DTCs.
Using SST, connect terminals TC and CG of the DLC3.
| *a | Front view of DLC3 |
Turn the power switch on (IG).
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
Check that the warning light indicates a normal system code.
Remove SST from the terminals of the DLC3.
The DTCs cannot be cleared by disconnecting the auxiliary battery terminal or the ECU-IG1 NO. 1 fuse.
END OF DTC CHECK/CLEAR
Turn the power switch on (IG).
Check that the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights go off when the power switch is turned on (ready).