Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM › 2012.10–2014.11
RM2070E _51 Engine / Hybrid System _061906 HYBRID / BATTERY CONTROL _0301574 HYBRID BATTERY SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM  P31B3-123  Hybrid Battery Voltage High  


DESCRIPTION

The power management control ECU monitors its internal operation and detects the following malfunction.

DTC No. INF Code DTC Detection Condition Trouble Area
P31B3 123 The power management control ECU detects a block voltage overcharge error signal.
·

HV battery

·

Power management control ECU




CAUTION / NOTICE / HINT

CAUTION:
·

When disposing of HV battery, make sure to return them through an authorized collection agent who is capable of handling them safely. If they are returned via the manufacturer specified route, they will be returned properly and in a safe manner by an authorized collection agent.

·

Before returning the HV battery, make sure to perform a recovery inspection (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HV BATTERY>RECOVERY INSPECTION)

·

Make a note of the output DTCs as some of them may be necessary for recovery inspection of the HV battery.



PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)

A

2.CHECK DTC OUTPUT (HYBRID CONTROL)

B

2.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


d.

Check if DTCs are output.

Result:
Result Proceed to
P31B3-123 is not output. A
DTCs shown in P31B3-123 and Table 1 are output simultaneously. B
DTCs shown in P31B3-123 and Table 2 are output simultaneously. C


Table 1:
DTC No. Relevant Diagnosis
P0A78-266, 267, 565, 586 Drive Motor "A" Inverter Performance
P0A94-564, 585, 587, 589, 590 DC/DC Converter Performance


Table 2:
DTC No. Relevant Diagnosis
P0AFC-123 Hybrid Battery Pack Sensor Module


HINT:

DTC P31B3-123 may be output simultaneously. In this case, troubleshoot the DTCs listed above first. Then, perform a reproduction test to check that no DTCs are output.



e.

Turn the power switch off.



A

3.REPLACE POWER MANAGEMENT CONTROL ECU

B

C

3.REPLACE POWER MANAGEMENT CONTROL ECU

(See page Power Source / Network>POWER DISTRIBUTION>POWER MANAGEMENT CONTROL ECU>COMPONENTS).

HINT:

Due to a power management control ECU malfunction, the HV battery has been charged abnormally. Therefore, the HV battery should be replaced at the same time as the power management control ECU.



NEXT