Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU › 2016.05–2020.08
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301637 DRIVING SUPPORT ECU A

CRUISE CONTROL  DRIVING SUPPORT ECU  INSTALLATION  


PROCEDURE

Hide 88150A 1.INSTALL DRIVING SUPPORT ECU ASSEMBLY (for LHD)

a.
E348638

Engage the claw to install the driving support ECU assembly.

HINT:

If the park assist ECU was removed, install it after installing the driving support ECU assembly (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU>INSTALLATION).



Hide 88150A 2.INSTALL DRIVING SUPPORT ECU ASSEMBLY (for RHD)

a.
E349659

Engage the claw to install the driving support ECU assembly.

HINT:

If the park assist ECU was removed, install it after installing the driving support ECU assembly (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU>INSTALLATION).



Hide 55550 5.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)

Hide 55607 6.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 55480D 7.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>INSTALLATION).


Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).