If the lane departure warning camera determines that the lane departure warning camera axis has deviated, DTC C1AA8 is stored. Also, if the camera axis adjustment is not performed after installing the lane departure warning camera, DTC C1AA9 is stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AA8 | While the power switch is on (IG) and the lane departure alert system is operating, the lane departure warning camera detects lane departure warning camera axis deviation. | ·
Lane departure warning camera ·
Windshield glass |
| C1AA9 | While the power switch is on (IG), the lane departure warning camera detects that lane departure warning camera adjustment has not been completed. | Lane departure warning camera |
When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).
When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.
Check the lane departure warning camera installation (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>INSTALLATION).
If the lane departure warning camera bracket is deformed or misaligned, replace the windshield glass (See page Vehicle Exterior>WINDOW / GLASS>WINDSHIELD GLASS>REMOVAL).
| Result | Proceed to |
|---|---|
| The lane departure warning camera bracket is not deformed or misaligned | A |
| The lane departure warning camera bracket is deformed or misaligned | B |
A
B
Perform the lane departure warning camera adjustment (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).
NEXT
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1AA8 and C1AA9 are not output | A |
| DTC C1AA8 or C1AA9 is output | B |
OK
B