G2148
1.INSTALL GENERATOR CABLE
Wear insulated gloves.
Install the generator cable to the hybrid vehicle transaxle assembly with the 3 bolts.
Keep the sealing surface of the generator cable and the connector terminal joint free of foreign matter.
Engage the 2 claws to install a new terminal cap.
When installing the terminal cap to the generator cable terminal block, keep the sealing surface free of foreign matter.
Place the generator cable connector shell in position and install it with the 3 bolts.
Connect the generator cable clamp to the motor cable bracket.
16577C
2.INSTALL RADIATOR PIPE
Install the radiator pipe to the hybrid vehicle transaxle assembly with the 2 bolts.
Connect the No. 3 radiator hose, No. 4 water by-pass hose and No. 1 radiator hose with the 3 clamps.
G9219A
3.INSTALL INVERTER TRAY BRACKET
G92A0A
4.INSTALL INVERTER RESERVE TANK ASSEMBLY
G9200
5.INSTALL INVERTER WITH CONVERTER ASSEMBLY
6.CONNECT WATER HOSE
82112
7.CONNECT NO. 2 ENGINE ROOM WIRE
G9221
8.REMOVE INVERTER COVER
82122
9.CONNECT NO. 2 ENGINE WIRE
G1148
10.CONNECT MOTOR CABLE
G2148
11.CONNECT GENERATOR CABLE
82164
12.CONNECT FRAME WIRE
13.CHECK HIGH VOLTAGE CABLE CONNECTION
G9221
14.INSTALL INVERTER COVER
82111
15.CONNECT ENGINE ROOM MAIN WIRE
G9214
16.INSTALL NO. 1 INVERTER BRACKET
G3834
17.INSTALL SERVICE PLUG GRIP
18.ADD COOLANT (for Inverter)
19.ADD COOLANT (for Engine)
20.INSPECT FOR COOLANT LEAK (for Inverter)
21.INSPECT FOR COOLANT LEAK (for Engine)
51441
22.INSTALL NO. 1 ENGINE UNDER COVER
53289A
23.INSTALL RADIATOR SUPPORT OPENING COVER