Home › Drivetrain › P410 (HYBRID TRANSMISSION / TRANSAXLE) › GENERATOR CABLE › from 2014.11
RM2070E _52 Drivetrain _061915 P410 HYBRID TRANSMISSION / TRANSAXLE _0301647 GENERATOR CABLE A

P410 HYBRID TRANSMISSION / TRANSAXLE  GENERATOR CABLE  INSTALLATION  


PROCEDURE

Hide G2148 1.INSTALL GENERATOR CABLE

NOTICE:

Wear insulated gloves.


a.

Install the generator cable to the hybrid vehicle transaxle assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Keep the sealing surface of the generator cable and the connector terminal joint free of foreign matter.



b.

Engage the 2 claws to install a new terminal cap.

NOTICE:

When installing the terminal cap to the generator cable terminal block, keep the sealing surface free of foreign matter.



c.
C209804

Place the generator cable connector shell in position and install it with the 3 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


d.

Connect the generator cable clamp to the motor cable bracket.


Hide 16577C 2.INSTALL RADIATOR PIPE

a.

Install the radiator pipe to the hybrid vehicle transaxle assembly with the 2 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


b.

Connect the No. 3 radiator hose, No. 4 water by-pass hose and No. 1 radiator hose with the 3 clamps.


Hide 51441 22.INSTALL NO. 1 ENGINE UNDER COVER

Hide 53289A 23.INSTALL RADIATOR SUPPORT OPENING COVER