Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY › 2012.03–2016.05
RM2070E _52 Drivetrain _061916 DRIVE SHAFT / PROPELLER SHAFT _0301657 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43040B 1.INSTALL FRONT DRIVE SHAFT HOLE SNAP RING

a.

Install a new front drive shaft hole snap ring to the front drive inboard joint assembly.

NOTICE:

Face the end gap of the front drive inboard joint hole snap ring downward.



Hide 43420 2.INSTALL FRONT DRIVE SHAFT ASSEMBLY

a.

Coat the lip of the hybrid vehicle transaxle assembly type T oil seal with MP grease.


b.
C208486

Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly.

NOTICE:
·

Face the end gap of the front drive shaft hole snap ring downward.

·

Do not damage the hybrid vehicle transaxle assembly type T oil seal.

·

Do not damage the inboard joint boot.

·

Make sure to center the front drive shaft assembly during installation to prevent damage to the front drive shaft hole snap ring.



HINT:

Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.



c.
C208473E05
1.677,1.042 2.604,1.26 2.604,1.26 1.594,0.833 true 2.656,1.219 2.823,1.375 0.167,0.156 10 false *a

Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.

Text in Illustration
*a Matchmark


Hide 48069 3.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

Hide 48810 4.INSTALL FRONT STABILIZER LINK ASSEMBLY

Hide 45047 5.CONNECT TIE ROD END SUB-ASSEMBLY

Hide 43502H 8.INSTALL FRONT AXLE SHAFT NUT

a.

Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using a non-residue solvent.

HINT:
·

Be sure to perform this work even when using a new drive shaft.

·

Keep the threaded parts free of oil and foreign matter.




b.
C210914

Using a socket wrench (30 mm), install the axle shaft nut.

Torque:
216 N*m (2203 kgf*cm, 159 ft.*lbf)


c.

Using a chisel and hammer, stake the front axle shaft nut.


Hide 11.INSTALL FRONT WHEELS

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 12.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Hide 51444A 13.INSTALL REAR ENGINE UNDER COVER LH

Hide 51443C 14.INSTALL REAR ENGINE UNDER COVER RH

Hide 51441 15.INSTALL NO. 1 ENGINE UNDER COVER