Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
43040B
1.INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
Install a new front drive shaft hole snap ring to the front drive inboard joint assembly.
Face the end gap of the front drive inboard joint hole snap ring downward.
43420
2.INSTALL FRONT DRIVE SHAFT ASSEMBLY
Coat the lip of the hybrid vehicle transaxle assembly type T oil seal with MP grease.
Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly.
Face the end gap of the front drive shaft hole snap ring downward.
Do not damage the hybrid vehicle transaxle assembly type T oil seal.
Do not damage the inboard joint boot.
Make sure to center the front drive shaft assembly during installation to prevent damage to the front drive shaft hole snap ring.
Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.
Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.
| *a | Matchmark |
48069
3.CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
48810
4.INSTALL FRONT STABILIZER LINK ASSEMBLY
45047
5.CONNECT TIE ROD END SUB-ASSEMBLY
47313J
6.INSTALL FRONT FLEXIBLE HOSE
89543
7.INSTALL FRONT SPEED SENSOR
43502H
8.INSTALL FRONT AXLE SHAFT NUT
Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using a non-residue solvent.
Be sure to perform this work even when using a new drive shaft.
Keep the threaded parts free of oil and foreign matter.
Using a socket wrench (30 mm), install the axle shaft nut.
Using a chisel and hammer, stake the front axle shaft nut.
9.ADD HYBRID TRANSAXLE FLUID
10.INSPECT HYBRID TRANSAXLE FLUID
11.INSTALL FRONT WHEELS
12.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
51444A
13.INSTALL REAR ENGINE UNDER COVER LH
51443C
14.INSTALL REAR ENGINE UNDER COVER RH
51441
15.INSTALL NO. 1 ENGINE UNDER COVER
16.CHECK FOR SPEED SENSOR SIGNAL