Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM › 2014.11–2015.08
RM2070E _54 Brake _061923 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0301683 ELECTRONICALLY CONTROLLED BRAKE SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM  PROBLEM SYMPTOMS TABLE  


If there are no DTCs but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTICE:

When replacing the brake booster with master cylinder (skid control ECU), sensor, etc., make sure that the power switch is turned off (lock), the stop light switch is off, and 2 minutes have elapsed since the driver's door was closed.


HINT:
·

Since the hydraulic passage is blocked off by the master cut solenoid during electronically controlled brake system control, there is no kickback (vibration) to the brake pedal, creating a quiet sound even while the ABS is operating.

·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Electronically Controlled Brake System
Symptom Suspected Area See page
ABS, BA and/or EBD does not operate Use a chassis dynamometer, etc. to check the electronically controlled brake system operation. -
Check the DTC again and make sure that the normal system code is output. (Click here)
IG power source circuit (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Check the brake booster with master cylinder (brake actuator) using the GTS. (Check brake booster with master cylinder (brake actuator) operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake booster with master cylinder (skid control ECU) (for LHD). (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake booster with master cylinder (skid control ECU) (for RHD). (Click here)
ABS, BA and/or EBD does not operate efficiently Check the DTC again and make sure that the normal system code is output. (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Check the brake booster with master cylinder (brake actuator) using the GTS. (Check brake booster with master cylinder (brake actuator) operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake booster with master cylinder (skid control ECU) (for LHD). (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake booster with master cylinder (skid control ECU) (for RHD). (Click here)
ABS warning light abnormal (Remains on) ABS warning light circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
ABS warning light abnormal (Does not come on) ABS warning light circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
Brake warning light / red (malfunction) abnormal (Remains on) Brake fluid level warning switch circuit (Click here)
Brake warning light / red (malfunction) circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
Brake warning light / red (malfunction) abnormal (Does not come on) Brake warning light / red (malfunction) circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
VSC and/or TRC does not operate Check that traction control has not operated by carrying out diagnosis. -
Check the DTC again and make sure that the normal system code is output. (Click here)
IG power source circuit (Click here)
Check the hydraulic circuit for leaks. -
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Yaw rate and acceleration sensor circuit (Click here)
Steering angle sensor circuit (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake booster with master cylinder (skid control ECU) (for LHD). (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake booster with master cylinder (skid control ECU) (for RHD). (Click here)
Brake warning light / yellow (minor malfunction) abnormal (Remains on) Brake warning light / yellow (minor malfunction) circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
Brake warning light / yellow (minor malfunction) abnormal (Does not come on) Brake warning light / yellow (minor malfunction) circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
Slip indicator light abnormal (Remains on) Slip indicator light circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
Slip indicator light abnormal (Does not come on) Slip indicator light circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
DTC check cannot be done Check the DTC again and make sure that the normal system code is output. (Click here)
TC and CG terminal circuit (Click here)
If the symptoms still occur even after the above circuit in suspected areas has been inspected and proved to be normal, replace the brake booster with master cylinder (skid control ECU) (for LHD). (Click here)
If the symptoms still occur even after the above circuit in suspected areas has been inspected and proved to be normal, replace the brake booster with master cylinder (skid control ECU) (for RHD). (Click here)
Sensor check cannot be done TS and CG terminal circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)
Meter buzzer abnormal Meter buzzer circuit (Click here)
Brake booster with master cylinder (Skid control ECU) (for LHD) (Click here)
Brake booster with master cylinder (Skid control ECU) (for RHD) (Click here)