Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM › 2016.05–2020.08
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301741 INTELLIGENT PARKING ASSIST SYSTEM C

PARK ASSIST / MONITORING  INTELLIGENT PARKING ASSIST SYSTEM  C164A  EPS Communication Malfunction  


DESCRIPTION

The power steering system receives intelligent parking assist system information from the parking assist ECU via CAN communication. This DTC is stored if the parking assist ECU receives abnormal signals from the power steering ECU assembly.

DTC No. DTC Detection Condition Trouble Area
C164A EPS communication malfunction
·

Parking assist ECU

·

Power steering system

·

Power steering ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When the "System initializing" message is displayed on the radio and display receiver assembly*1 or navigation receiver assembly*2 after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).

·

If initialization is necessary while performing an inspection, perform initialization first and then proceed to the next step.


*1: for Radio and Display Type

*2: for Navigation Receiver Type



PROCEDURE

1.CHECK DTC OUTPUT

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C164A is output A
DTCs are not output B


HINT:
·

If the DTC is not output again when rechecking for DTCs, it may have been stored due to a temporary communication problem between the parking assist ECU and power steering ECU.

·

If DTC C164A is output frequently, duplicate the problem symptoms and perform the inspection again, even if the DTC is not output when rechecking for DTCs (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).





A

2.REPLACE PARKING ASSIST ECU

B

2.REPLACE PARKING ASSIST ECU

NEXT

3.CHECK DTC OUTPUT
3.CHECK DTC OUTPUT

A

4.CHECK DTC OUTPUT (POWER STEERING SYSTEM)

B

END

4.CHECK DTC OUTPUT (POWER STEERING SYSTEM)
a.

Check for power steering system DTCs.

HINT:

Power steering System (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).


Result:
Result Proceed to
DTCs are not output A
Power steering system DTC is output B




A

REPLACE POWER STEERING ECU ASSEMBLY

B