The brake booster with master cylinder (skid control ECU) receives brake control request signals from the power management control ECU and driving support ECU assembly.
When the request signals received from the power management control ECU and driving support ECU assembly are not consistent, the brake booster with master cylinder (skid control ECU) determines that a malfunction has occurred and sends a malfunction signal to the driving support ECU assembly.
If the driving support ECU assembly receives a malfunction signal, DTC C1A41 is stored.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A41 | While the power switch is on (IG), a brake request signal from the power management control ECU and driving support ECU assembly are inconsistent for 3 seconds. | ·
Electronically controlled brake system ·
Hybrid control system ·
Brake booster with master cylinder (skid control ECU) ·
Power management control ECU ·
Driving support ECU assembly |
Check DTCs for the electronically controlled brake system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
Electronically controlled brake system DTC is not output.
OK
NG
Check DTCs for the hybrid control system (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR).
Hybrid control system DTC is not output.
OK
NG
Replace the brake booster with master cylinder (skid control ECU) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL (for LHD), See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL (for RHD)).
NEXT
Using the GTS, enter the following menus: Body Electrical / Pre-Crash 2 / Trouble Codes.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
DTC C1A41 is not output.
OK
NG
Replace the power management control ECU (See page Power Source / Network>POWER DISTRIBUTION>POWER MANAGEMENT CONTROL ECU>REMOVAL).
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus:
Body Electrical / Pre-Crash 2 / Trouble Codes.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
DTC C1A41 is not output.
OK
NG