The brake booster with master cylinder (skid control ECU) receives vehicle stability signals from the yaw rate sensor and sends the signals to the driving support ECU assembly and power management control ECU. If the brake booster with master cylinder (skid control ECU) detects that the yaw rate sensor is malfunctioning, the brake booster with master cylinder (skid control ECU) sends a malfunction signal to the driving support ECU assembly, and the driving support ECU assembly stores DTC C1A46. Also, when DTC C1A46 is stored, the brake booster with master cylinder (skid control ECU) stores DTC C1234 at the same time.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A46 | While the vehicle speed is 5 km/h (4 mph) or more, a yaw rate sensor malfunction signal is received from the brake booster with master cylinder (skid control ECU) for 13 seconds or more. | ·
CAN communication system ·
Yaw rate sensor ·
Brake booster with master cylinder (skid control ECU) ·
Driving support ECU assembly |
This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.
Check DTCs for the electronically controlled brake system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
DTC C1234 is not output.
OK
NG
Replace the brake booster with master cylinder (skid control ECU) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL (for LHD), See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL (for RHD)).
NEXT
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus:
Body Electrical / Pre-Crash 2 / Trouble Codes.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Drive the vehicle and attempt to reproduce the conditions present when the DTC was detected.
Recheck for DTCs.
DTC C1A46 is not output.
OK
NG