Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A47  Steering Angle Sensor  


DESCRIPTION

The brake booster with master cylinder (skid control ECU) receives steering rotation angle information from the steering angle sensor, and sends the information to the driving support ECU assembly via CAN communication.

If the brake booster with master cylinder (skid control ECU) detects a malfunction of the steering angle sensor, it sends a malfunction signal to the driving support ECU assembly and stores a DTC.

DTC No. DTC Detection Condition Trouble Area
C1A47 While the vehicle speed is 50 km/h (32 mph) or more, a steering angle sensor malfunction signal is received from the brake booster with master cylinder (skid control ECU) for 2 seconds or more.
·

CAN communication system

·

Steering angle sensor

·

Brake booster with master cylinder (skid control ECU)

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.


PROCEDURE

1.CHECK DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check DTCs for the electronically controlled brake system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).

OK:

Electronically controlled brake system DTC is not output.




OK

2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER (SKID CONTROL ECU)

NG

2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER (SKID CONTROL ECU)
a.

Replace the brake booster with master cylinder (skid control ECU) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL (for LHD), See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL (for RHD)).



NEXT

3.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
3.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash 2 / Trouble Codes.




f.

Drive the vehicle and attempt to reproduce the conditions present when the DTC was detected.


g.

Recheck for DTCs.

OK:

DTC C1A47 is not output.




OK

END BRAKE BOOSTER WITH MASTER CYLINDER (SKID CONTROL ECU) WAS DEFECTIVE

NG

REPLACE DRIVING SUPPORT ECU ASSEMBLY