Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A4A  Skid Control Buzzer Circuit  


DESCRIPTION

Based on pre-crash control, the driving support ECU assembly provides warnings to the driver. The driving support ECU assembly does this by sending a request signal to the brake booster with master cylinder (skid control ECU) to sound the skid control buzzer.

When the brake booster with master cylinder (skid control ECU) detects a malfunction in the VSC warning buzzer circuit, a malfunction signal is sent to the driving support ECU assembly, and this DTC is stored. Although the brake booster with master cylinder (skid control ECU) sends a malfunction signal to the driving support ECU assembly, the vehicle stability control system does not store a relevant malfunction detection DTC.

DTC No. DTC Detection Condition Trouble Area
C1A4A While the power switch is on (IG), a skid control buzzer circuit malfunction signal is received from the brake booster with master cylinder (skid control ECU) for 3 seconds or more.
·

Skid control buzzer circuit

·

Brake booster with master cylinder (skid control ECU)

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (SKID CONTROL BUZZER)
a.

Select the Active Test, use the GTS to generate a control command, then check that the skid control buzzer sounds (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DATA LIST / ACTIVE TEST).

ABS/VSC/TRAC
Tester Display Test Part Control Range Diagnostic Note
DSS Signal Buzzer Skid control buzzer Buzzer ON/OFF Buzzer can be heard

OK:

Skid control buzzer sounds.




OK

2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER (SKID CONTROL ECU)

NG

2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER (SKID CONTROL ECU)
a.

Replace the brake booster with master cylinder (skid control ECU) (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL (for LHD), See page Brake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL (for RHD)).



NEXT

3.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
3.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash 2 / Trouble Codes.




f.

Recheck for DTCs.

OK:

DTC C1A4A is not output.




OK

END BRAKE BOOSTER WITH MASTER CYLINDER (SKID CONTROL ECU) WAS DEFECTIVE

NG

REPLACE DRIVING SUPPORT ECU ASSEMBLY