Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU › from 2020.08
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301637 DRIVING SUPPORT ECU A

CRUISE CONTROL  DRIVING SUPPORT ECU  INSTALLATION  


PROCEDURE

Hide 88150A 1.INSTALL DRIVING SUPPORT ECU ASSEMBLY (for LHD)

a.
E348638

Engage the claw to install the driving support ECU assembly.


Hide 88150A 2.INSTALL DRIVING SUPPORT ECU ASSEMBLY (for RHD)

a.
E349659

Engage the claw to install the driving support ECU assembly.

HINT:

If the park assist ECU was removed, install it after installing the driving support ECU assembly (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU>INSTALLATION).



Hide 55550 5.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)

Hide 55607 6.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 55480D 7.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)

HINT:

Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>INSTALLATION).


Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).