CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK FOR OPEN IN CAN BUS LINES (ECM MAIN LINE) |
Disconnect the cable from the negative (-) auxiliary battery terminal.
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A40-13 (CANH) - A40-26 (CANL) | Cable disconnected from negative (-) auxiliary battery terminal | 108 to 132 Ω |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | |
| 2.CHECK ECM POWER SOURCE CIRCUIT |
Check the ECM power source circuit (Click here).
|
| ||||
| OK | ||
| ||