DTC B1476/76 A/C Inverter Load System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1476/76 | Motor rotation load while the compressor is operating is too large or too small |
|
| 1.CHECK CAN COMMUNICATION SYSTEM |
Use the Techstream to check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Electrical Fan | Electrical fan | OFF, ON | - |
|
| ||||
| OK | |
| 3.CHECK REFRIGERANT PRESSURE |
Install a manifold gauge set (Click here).
Turn the ignition switch to ON (READY).
![]() |
Read the manifold gauge pressure when the following conditions are established.
Prepare the vehicle according to the chart below.
| Item | Condition |
| Vehicle Doors | All fully open |
| Temperature Setting | MAX COLD |
| Blower Speed | HI |
| A/C switch | ON |
| R/F Switch | RECIRCULATION (30 to 35°C (86 to 95°F)) |
|
| ||||
| OK | ||
| ||