SMART KEY SYSTEM (for Start Function) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency, whether the problem occurred recently or has been occurring for a long time |
| Where | Whether the problem occurs at a specific location |
| Under what conditions? | Whether the doors were locked or unlocked, whether the power switch was on, whether the hybrid control system has started |
| How did it happen? | Problem symptoms* |
| |||||
| 3.INSPECT BASIC OPERATION |
Inspect auxiliary battery voltage with the power switch off.
Check for blown fuses, open or shorted wire harnesses, improperly connected connectors and other problems in areas that can be visually inspected.
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the Techstream to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| Engine immobiliser system DTC is output | B |
| Smart key system (for Entry Function) DTC is output | C |
| Smart key system (for Start Function) DTC is output | D |
|
| ||||
|
| ||||
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here)
Terminals of ECU (Click here)
Data List / Active Test (Click here)
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.CHECK FOR DTC* |
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
|
| ||||
|---|---|---|---|---|---|