METER / GAUGE SYSTEM > Speedometer Malfunction |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication DTCs are output (Click here).
| Result | Proceed to |
| DTCs are not output. | A |
| DTCs are output. | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (SPEED METER OPERATION) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Speed Meter Operation | Speedometer | OFF, 0, 40, 80, 120, 160 mph*1 | There is a deviation in the values displayed on the speedometer*1 (Control range → Speedometer display)
|
| OFF, 0, 40, 80, 120, 160 km/h*2 | There is a deviation in the values displayed on the speedometer*2 (Control range → Speedometer display)
|
|
| ||||
| OK | |
| 3.CHECK BRAKE CONTROL SYSTEM |
Check if brake control system DTCs are output (Click here).
| Result | Proceed to |
| DTCs are not output. | A |
| DTCs are output. | B |
|
| ||||
| A | |
| 4.READ VALUE USING TECHSTREAM (VEHICLE SPEED, VEHICLE SPEED METER) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus:
for ABS/VSC/TRAC: Chassis / ABS/VSC/TRAC / Data List.
for Combination Meter: Body Electrical / Combination Meter / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed | Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Vehicle Speed Meter | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) | Almost the same as actual vehicle speed | - |
| Result | Proceed to |
| The data list values of the ECUs match. | A |
| The data list values of the ECUs do not match. | B |
|
| ||||
| A | ||
| ||
| 5.REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly with a new or a known good one (Click here).
| Result | Proceed to |
| The operation of the speedometer returns to normal. | A |
| The operation of the speedometer does not return to normal. | B |
|
| ||||
| A | ||
| ||