Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Result of CAN No. 1 Bus Check 
Symptom
Suspected Area
See page
Open in CAN Main Bus Wire (for LHD)
CAN Main Bus Wire
Click here
Open in CAN Main Bus Wire (for RHD)
CAN Main Bus Wire
Click here
Short in CAN Bus Wires (for LHD)
CAN Bus Wires
Click here
Short in CAN Bus Wires (for RHD)
CAN Bus Wires
Click here
Short to +B in CAN Bus Wire (for LHD)
CAN Bus Wire
Click here
Short to +B in CAN Bus Wire (for RHD)
CAN Bus Wire
Click here
Short to GND in CAN Bus Wire (for LHD)
CAN Bus Wire
Click here
Short to GND in CAN Bus Wire (for RHD)
CAN Bus Wire
Click here
Open in One Side of CAN Branch Wire
CAN Branch Wire
Click here

HINT:
Refer to How to Proceed with Troubleshooting for the CAN No. 1 Bus Check procedure.


Communication Stop Mode Table 
Symptom
Suspected Area
See page
"ABS/VSC/TRC" is not displayed on the intelligent tester.
Skid Control ECU Communication Stop Mode
Click here
"EPS" is not displayed on the intelligent tester.
Power Steering ECU Communication Stop Mode
Click here
"Steering Angle Sensor" is not displayed on the intelligent tester.
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate/Deceleration Sensor" is not displayed on the intelligent tester.
Yaw Rate Sensor Communication Stop Mode
Click here
"Engine" is not displayed on the intelligent tester.
ECM Communication Stop Mode
Click here
"Transmission Control" is not displayed on the intelligent tester.
Transmission Control ECU Communication Stop Mode
Click here
"Main Body" is not displayed on the intelligent tester.
Main Body ECU Communication Stop Mode
Click here
"Hybrid Control" and "Electric Power Control" are not displayed on the intelligent tester.
Power Management Control ECU Communication Stop Mode
Click here
"Combination Meter" is not displayed on the intelligent tester.
Combination Meter ECU Communication Stop Mode
Click here
"Entry and Start/Wireless Tuner" is not displayed on the intelligent tester.
Certification ECU Communication Stop Mode
Click here
"SRS Airbag" is not displayed on the intelligent tester.
Center Airbag Sensor Communication Stop Mode
Click here
"AVN1" is not displayed on the intelligent tester.
Navigation ECU Communication Stop Mode
Click here
"AVN1" is not displayed on the intelligent tester.
Audio Receiver Assembly Communication Stop Mode
Click here