DTC C1A4A Skid Control Buzzer Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1A4A | When the power switch is on (IG), a skid control buzzer circuit malfunction signal is received from the brake booster with master cylinder (skid control ECU). |
|
| 1.PERFORM ACTIVE TEST USING TECHSTREAM (SKID CONTROL BUZZER) |
Select the Active Test, use the Techstream to generate a control command, then check that the skid control buzzer sounds (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Buzzer | Skid control buzzer sounds | ON/OFF | - |
|
| ||||
| OK | |
| 2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER |
Replace the brake booster with master cylinder (skid control ECU) (Click here).
| NEXT | |
| 3.CHECK DTC OUTPUT (PRE-COLLISION SYSTEM) |
Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.
Clear the DTCs (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||