Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM
RM3210E _56 Audio / Visual / Telematics _047512 PARK ASSIST / MONITORING _0232459 PARKING ASSIST MONITOR SYSTEM J

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  Image from Camera for Parking Assist Monitor is Abnormal  


DESCRIPTION

The video signal from the rear television camera assembly is transmitted to the navigation receiver assembly*1 or radio and display receiver assembly*2.

*1: for Navigation Receiver Type

*2: for Radio and Display Receiver Type


WIRING DIAGRAM

E345336E01
0.135,2.354 2.229,2.563 2.094,0.208 10 false Navigation Receiver Assembly*1 0.135,3.313 2.677,3.51 2.542,0.198 10 false *1: for Navigation Receiver Type 0.125,2.719 2.667,2.917 2.542,0.198 10 false Radio and Display Receiver Assembly*2 2.552,3.344 5.135,3.542 2.583,0.198 10 false *2: for Radio and Display Receiver Type 5.615,3.354 6.604,3.573 0.99,0.219 10 false *3: Shielded 5.24,2.479 7.063,2.792 1.823,0.313 10 false Television Camera Assembly 5.24,2.313 7.063,2.625 1.823,0.313 10 false R5 1.219,1.813 1.677,2.021 0.458,0.208 10 false CGND 1.448,1.427 1.906,1.635 0.458,0.208 10 false V- 1.417,1.042 1.875,1.25 0.458,0.208 10 false V+ 1.344,0.625 1.802,0.833 0.458,0.208 10 false CA+ 1.76,0.438 2.219,0.646 0.458,0.208 10 false 11*1 1.74,0.833 2.198,1.042 0.458,0.208 10 false 12*1 1.75,1.625 2.208,1.833 0.458,0.208 10 false 23*1 1.75,1.24 2.208,1.448 0.458,0.208 10 false 24*1 2.146,0.427 2.604,0.635 0.458,0.208 10 false 11*2 2.135,0.854 2.594,1.063 0.458,0.208 10 false 12*2 2.156,1.229 2.615,1.438 0.458,0.208 10 false 24*2 2.135,1.635 2.594,1.844 0.458,0.208 10 false 23*2 2.146,0.625 2.458,0.823 0.313,0.198 10 false F34 2.146,1.031 2.458,1.229 0.313,0.198 10 false F34 2.156,1.438 2.469,1.635 0.313,0.198 10 false F34 2.146,1.823 2.458,2.021 0.313,0.198 10 false F34 1.75,1.823 2.063,2.021 0.313,0.198 10 false F95 1.76,1.427 2.073,1.625 0.313,0.198 10 false F95 1.771,1.031 2.083,1.229 0.313,0.198 10 false F95 1.75,0.625 2.063,0.823 0.313,0.198 10 false F95 5.427,0.615 5.885,0.823 0.458,0.208 10 false CB+ 5.438,1.031 5.896,1.24 0.458,0.208 10 false CV+ 5.417,1.406 5.875,1.615 0.458,0.208 10 false CV- 5.417,1.854 5.875,2.063 0.458,0.208 10 false CGND 5.208,0.542 5.688,0.729 0.479,0.188 10 false 6 5.198,0.906 5.708,1.094 0.51,0.188 10 false 3 5.208,1.302 5.719,1.49 0.51,0.188 10 false 2 5.208,1.698 5.719,1.885 0.51,0.188 10 false 5 3.906,1.646 5.729,1.958 1.823,0.313 10 false *3

CAUTION / NOTICE / HINT

NOTICE:
·

If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



HINT:

Images may be unclear even in normal conditions if:

·

Electrical devices are used in the cabin (noise may occur in the image).

·

Accessories that generate radio waves have been installed (noise may occur in the image).

·

The outer mirror switch assembly is operated (noise may occur in the image).

·

The multi-display is cold (the image immediately after turning the power switch on (IG) may be blurred or darker than normal).

·

The camera lens is dirty with snow, mud, etc.

·

A strong beam of light, such as a sunbeam or headlight, hits the camera.

·

It is too dark around the camera (at night, etc.).

·

The ambient temperature around the camera is either too high or too low.

·

The vehicle is tilted at a steep angle.

·

The rear television camera assembly lens is scratched.

·

The rear television camera assembly lens has drops of water on it or the humidity is high.

·

When the camera is used under fluorescent lights, sodium lights, mercury lights, etc., the lights and the illuminated area may appear to flicker.



PROCEDURE

1.CONFIRM MODEL
a.

Choose the model to be inspected.


Result:
Result Proceed to
for Navigation Receiver Type A
for Radio and Display Receiver Type B



A

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

B

4.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

OK

3.REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.REPLACE REAR TELEVISION CAMERA ASSEMBLY
a.

Replace the rear television camera assembly with a new or known good one.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA>REMOVAL


b.

Check that the parking assist monitor system operates normally.

OK:

Parking assist monitor system operates normally.



Result:
Proceed to
OK
NG



OK

END

NG

4.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

OK

5.REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.REPLACE REAR TELEVISION CAMERA ASSEMBLY
a.

Replace the rear television camera assembly with a new or known good one.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA>REMOVAL


b.

Check that the parking assist monitor system operates normally.

OK:

Parking assist monitor system operates normally.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY