Wear protective gloves. Sharp areas on the parts may injure your hands.
71512S
1.INSTALL OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)
Engage the 13 claws to install the occupant detection sensor (separate type front seat cushion pad) to the separate type front seat cushion cover.
2.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
3.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
71861
4.INSTALL FRONT SEAT INNER CUSHION SHIELD
71811D
5.INSTALL FRONT SEAT CUSHION SHIELD
72526A
6.INSTALL RECLINING ADJUSTER RELEASE HANDLE
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
72551
7.INSTALL NO. 1 RECLINING HINGE COVER
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
71074S
8.CONNECT SEPARATE TYPE FRONT SEATBACK COVER
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REASSEMBLY
73230
9.INSTALL FRONT SEAT INNER BELT ASSEMBLY
10.INSTALL FRONT SEAT ASSEMBLY
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION
11.INSPECT SRS WARNING LIGHT