Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY
RM3210E _58 Vehicle Interior _047538 SEAT BELT _0234844 REAR SEAT OUTER BELT ASSEMBLY A

SEAT BELT  REAR SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear seat outer belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

CAUTION:
·
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If an SRS part is accidentally deployed, it may cause a serious injury.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64910J 3.REMOVE TONNEAU COVER ASSEMBLY

Hide 58415E 4.REMOVE REAR NO. 1 FLOOR BOARD

Hide 58432D 5.REMOVE DECK BOARD RETAINER

Hide 64997 6.REMOVE DECK FLOOR BOX LH (w/o Spare Tire)

Hide 64995 7.REMOVE DECK FLOOR BOX RH (w/o Spare Tire)

Hide 64993 8.REMOVE REAR DECK FLOOR BOX (w/ Compact Spare Tire)

Hide 64997 9.REMOVE DECK FLOOR BOX LH (w/ Compact Spare Tire)

Hide 64995 10.REMOVE DECK FLOOR BOX RH (w/ Compact Spare Tire)

Hide 64995 11.REMOVE DECK FLOOR BOX RH (w/ Full Size Spare Tire)

Hide 64997 12.REMOVE DECK FLOOR BOX LH (w/ Full Size Spare Tire)

Hide 64718D 13.REMOVE DECK TRIM SERVICE HOLE COVER

Hide 58460D 14.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Rear Side)

Hide 64716D 15.REMOVE REAR DECK TRIM COVER

Hide 67918A 16.REMOVE REAR DOOR SCUFF PLATE

Hide 62332A 17.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

Hide 71940A 18.REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side)

Hide 71940A 19.REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)

Hide 71960B 20.REMOVE REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)

Hide 73350C 21.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Hide 22.REMOVE REAR SEATBACK ASSEMBLY RH (for RH Side)

Hide 23.REMOVE REAR SEATBACK ASSEMBLY LH (for LH Side)

Hide 24.REMOVE REAR SEAT CUSHION ASSEMBLY

Hide 72693 25.REMOVE REAR SEAT CUSHION LOCK HOOK

Hide 76974F 26.REMOVE REAR UNDER SIDE COVER

Hide 71304C 27.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY

Hide 62552F 28.REMOVE REAR SEAT SIDE GARNISH

Hide 58460D 29.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Side)

Hide 64937A 30.REMOVE NO. 1 TONNEAU COVER HOLDER CAP

Hide 64938 31.REMOVE TONNEAU COVER HOOK A

Hide 81330 32.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)

Hide 64740C 33.REMOVE DECK TRIM SIDE PANEL ASSEMBLY

Hide 62480A 34.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY

Hide 73370 35.REMOVE REAR 3 POINT TYPE SEAT OUTER BELT ASSEMBLY LH (for LH Side)

a.
B435041

Remove the bolt to disconnect the floor anchor of the rear 3 point type seat outer belt assembly LH.


b.
B441529

w/o Pretensioner:

i.

Remove the 3 bolts.


ii.

Disengage the 3 guides to remove the rear 3 point type seat outer belt assembly LH.



c.
B441533C04
0.896,0.74 1.146,0.594 true 1.208,0.958 1.417,0.885 true 1.198,0.51 1.438,0.74 0.24,0.229 10 false *a 1.448,0.781 1.677,1.01 0.229,0.229 10 false *b 0.583,0.333 0.823,0.542 0.24,0.208 10 false *c
*a Locking Button
*b Protective Tape
*c Release


w/ Pretensioner:

i.

Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

HINT:

Tape the screwdriver tip before use.



ii.
B441534

Remove the 3 bolts.


iii.

Disengage the 3 guides to remove the rear 3 point type seat outer belt assembly LH.



Hide 73360 36.REMOVE REAR 3 POINT TYPE SEAT OUTER BELT ASSEMBLY RH (for RH Side)

a.
B435014

Remove the bolt to disconnect the floor anchor of the rear 3 point type seat outer belt assembly RH.


b.
B441521

w/o Pretensioner:

i.

Remove the 3 bolts.


ii.

Disengage the 3 guides to remove the rear 3 point type seat outer belt assembly RH.



c.
B435010

w/ Pretensioner:

i.

Remove the 3 bolts.


ii.

Disengage the 3 guides.


iii.
B440085C02
0.646,0.688 0.865,0.771 true 0.896,0.49 1.094,0.594 true 0.74,0.385 0.979,0.604 0.24,0.219 10 false *a 0.49,0.604 0.75,0.823 0.26,0.219 10 false *b 1.229,0.24 1.49,0.458 0.26,0.219 10 false *c
*a Locking Button
*b Protective Tape
*c Release


Disengage the clamp.


iv.

Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

HINT:

Tape the screwdriver tip before use.



v.

Remove the rear 3 point type seat outer belt assembly RH.