89422D
1.INSTALL NO. 2 ENGINE COOLANT TEMPERATURE SENSOR (w/ Flow Shutting Valve (Water Valve))
Apply a light coat of engine coolant to the O-ring of the No. 2 engine coolant temperature sensor.
Install the No. 2 engine coolant temperature sensor to the No. 2 water by-pass pipe with the clip.
If the No. 2 engine coolant temperature sensor has been struck or dropped, replace it.
If reusing the No. 2 engine coolant temperature sensor, be sure to inspect the O-ring.
Make sure that the O-ring is not cracked or moved out of place when installing the No. 2 engine coolant temperature sensor.
Connect the No. 2 engine coolant temperature sensor connector.
G9200
2.INSTALL INVERTER WITH CONVERTER ASSEMBLY (w/ Flow Shutting Valve (Water Valve))
89422
3.INSTALL ENGINE COOLANT TEMPERATURE SENSOR
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>2ZR-FXE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module:
Click hereEngine / Hybrid System>2ZR-FXE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>INITIALIZATION
Install a new gasket to the engine coolant temperature sensor.
Using SST, install the engine coolant temperature sensor to the water outlet.
If the engine coolant temperature sensor has been struck or dropped, replace it.
Connect the engine coolant temperature sensor connector.
25610
4.INSTALL EGR PIPE ASSEMBLY
5.ADD ENGINE COOLANT (for Engine)
6.INSPECT FOR COOLANT LEAK (for Engine)
51444C
7.INSTALL REAR MOTOR UNDER COVER LH
12601B
8.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
9.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>2ZR-FXE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module:
Click hereEngine / Hybrid System>2ZR-FXE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>INITIALIZATION