Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0243312 GRILLE SHUTTER A

EXTERIOR PANELS / TRIM  GRILLE SHUTTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during grille shutter removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly
·

Ultrasonic sensor detection angle (w/ TOYOTA Parking Assist-sensor System)

·

Ultrasonic sensor detection angle registration (w/ TOYOTA Parking Assist-sensor System)


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)
Change grille shutter control mode and/or perform initialization Grille Shutter system (Click here)
·

Swing grill actuator assembly

·

Radiator shutter sub-assembly


Change grille shutter control mode and/or perform initialization Grille Shutter system (Click here)

PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 52611 2.REMOVE FRONT BUMPER ENERGY ABSORBER (for Type A)

Hide 52136H 3.REMOVE FRONT ENERGY ABSORBER MOUNTING REINFORCEMENT LH (for Type B)

Hide 52135J 4.REMOVE FRONT ENERGY ABSORBER MOUNTING REINFORCEMENT RH (for Type B)

HINT:

Use the same procedure for the LH side.


Hide 52611 5.REMOVE FRONT BUMPER ENERGY ABSORBER (for Type B)

Hide 52618 6.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 53019B 8.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY (for Type A)

a.
B435999

Disconnect the connector.


b.

Disengage the clamp.


c.
B436000

Remove the 3 bolts.


d.
B436001C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 guides as shown in the illustration to remove the radiator shutter sub-assembly.


Hide 53019B 9.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY (for Type B)

a.

Disconnect the connector.

B436093


b.

Disengage the 2 clamps.


c.

Remove the 3 bolts.

B436094


d.
B436001C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 guides as shown in the illustration to remove the radiator shutter sub-assembly.