Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0243315 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear door belt moulding removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
·

Rear door glass sub-assembly

·

Rear door glass run


Initialize Power Window Control System
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Window open warning function


(Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 69284G 3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 74260 4.REMOVE REAR ARMREST ASSEMBLY

Hide 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP WITH REAR DOOR NO. 2 VENT SEAL

Hide 67842E 8.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 67858B 9.REMOVE REAR DOOR PANEL PROTECTOR

Hide 67844A 10.REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER

Hide 68152C 11.REMOVE REAR DOOR GLASS RUN

Hide 67872 12.DISCONNECT REAR DOOR WEATHERSTRIP

Hide 67408E 13.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 68124B 14.REMOVE REAR DOOR QUARTER WINDOW GLASS

Hide 68104 15.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 75740 16.REMOVE REAR DOOR BELT MOULDING ASSEMBLY

a.
B436019C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear door belt moulding assembly.


b.
B436020C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 8 claws as shown in the illustration to remove the rear door belt moulding assembly.