Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE(for Front Door)
RM3210E _59 Vehicle Exterior _047542 EXTERIOR PANELS / TRIM _0243325 BLACK OUT TAPE(for Front Door) A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE(for Front Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during black out tape removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)
·

Front door glass sub-assembly

·

Front door glass run


Initialize Power Window Control System
·

Auto up and down function

·

Jam protection function

·

Catch protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Window open warning function


(Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 69284F 3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 74220 4.REMOVE FRONT ARMREST ASSEMBLY

Hide 5.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 81230 7.REMOVE COURTESY LIGHT ASSEMBLY

Hide 67602 8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 9.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL

Hide 67856B 10.REMOVE FRONT DOOR PANEL PROTECTOR

Hide 87940 11.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

Hide 67836C 12.REMOVE FRONT DOOR NO. 3 SERVICE HOLE COVER

Hide 67832 13.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68102 14.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67862 15.DISCONNECT FRONT DOOR WEATHERSTRIP

Hide 68151D 16.REMOVE FRONT DOOR GLASS RUN

Hide 67402F 17.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY

Hide 68126 18.REMOVE FRONT DOOR FIX WINDOW GLASS

Hide 67664C 19.REMOVE DOOR FRAME GARNISH

Hide 75966B 20.REMOVE FRONT DOOR REAR OUTSIDE STRIPE

HINT:

When removing the front door rear outside stripe, heat the vehicle body and front door rear outside stripe using a heat light.


Heating Temperature
Item Temperature
Front Door Rear Outside Stripe and Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the vehicle body excessively.


a.

Using a heat light, heat the front door rear outside stripe and vehicle body.


b.
B440941

Pull back on one of the ends of the front door rear outside stripe to remove it.

HINT:

When pulling on the front door rear outside stripe, pull it parallel to the vehicle body.



Hide 75986B 21.REMOVE FRONT DOOR STRIPE

HINT:

When removing the front door stripe, heat the vehicle body and front door stripe using a heat light.


Heating Temperature
Item Temperature
Front Door Stripe and Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the vehicle body excessively.


a.

Using a heat light, heat the front door stripe and vehicle body.


b.
B440942

Pull back on one of the ends of the front door stripe to remove it.

HINT:

When pulling on the front door stripe, pull it parallel to the vehicle body.



Hide 75976G 22.REMOVE FRONT DOOR LOWER OUTSIDE STRIPE

HINT:

When removing the front door lower outside stripe, heat the vehicle body and front door lower outside stripe using a heat light.


Heating Temperature
Item Temperature
Front Door Lower Outside Stripe and Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the vehicle body excessively.


a.

Using a heat light, heat the front door lower outside stripe and vehicle body.


b.
B440943

Pull back on one of the ends of the front door lower outside stripe to remove it.

HINT:

When pulling on the front door lower outside stripe, pull it parallel to the vehicle body.