Use the same procedure for the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly.
46430
1.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
Insert the No. 3 parking brake cable assembly into the vehicle body.
Install the No. 3 parking brake cable assembly with the 4 bolts and nut.
| *1 | Rear Disc Brake Cylinder Assembly |
| *a | Clip |
Engage the clip to install the No. 3 parking brake cable assembly to the rear disc brake cylinder assembly.
Be sure to engage the clip to the rear disc brake cylinder assembly as shown in the illustration.
Connect the No. 3 parking brake cable assembly to the rear disc brake cylinder assembly.
47658B
2.INSTALL PARKING BRAKE LEVER PROTECTOR
Install the parking brake lever protector to the No. 3 parking brake cable assembly.
57628C
3.INSTALL REAR FLOOR SIDE MEMBER COVER LH (for LH Side)
w/ Canister Pump Module:
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL TANK(w/ Canister Pump Module)>INSTALLATION
w/o Canister Pump Module:
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL TANK(w/o Canister Pump Module)>INSTALLATION
58390
4.INSTALL NO. 1 FLOOR UNDER COVER ASSEMBLY (for RH Side)
w/ Canister Pump Module:
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL TANK(w/ Canister Pump Module)>INSTALLATION
w/o Canister Pump Module:
Click hereEngine / Hybrid System>2ZR-FXE FUEL>FUEL TANK(w/o Canister Pump Module)>INSTALLATION
58153
5.INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR
Install the front No. 2 floor heat insulator with the 4 nuts.
17410
6.INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
46302
7.CONNECT NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY
Connect the No. 1 parking brake pull rod sub-assembly to the No. 3 parking brake cable assembly as shown in the illustration.
46410
8.CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY
58910C
9.INSTALL REAR CONSOLE BOX ASSEMBLY
10.INSPECT PARKING BRAKE PEDAL TRAVEL
11.ADJUST PARKING BRAKE PEDAL TRAVEL