Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD
RM3210E _56 Audio / Visual / Telematics _047510 AUDIO / VIDEO _0243404 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT CLEARANCE SONAR SYSTEM>CALIBRATION

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55084E 2.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for RHD)

Hide 55085 3.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 55462C 4.REMOVE NO. 2 KNEE PROTECTOR BRACKET (for LHD)

Hide 55463D 5.REMOVE NO. 3 KNEE PROTECTOR BRACKET (for LHD)

Hide 86101 6.REMOVE ANTENNA CORD SUB-ASSEMBLY

a.

for LHD:

i.

Disengage the 6 clamps and remove the antenna cord sub-assembly.

E341895



b.

for RHD:

i.

Disengage the 4 clamps and remove the antenna cord sub-assembly.

E341897



Hide 86101H 7.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)

a.

w/ Navigation Antenna:

i.

Disengage the 6 clamps and remove the antenna cord sub-assembly.

E341898



Hide 8.REMOVE ROOF HEADLINING ASSEMBLY

Hide 86101J 9.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.

w/o Digital Audio Broadcasting Antenna or Television Antenna:

i.

Remove the adhesive tape from the roof headlining assembly.

E338067C02
0.094,0.104 0.469,0.344 0.375,0.24 12 false *A 0.135,4.031 0.51,4.271 0.375,0.24 12 false *B
*A w/o Sliding Roof *B w/ Sliding Roof
V100155

Adhesive Tape
V100136

Front




b.

w/ Digital Audio Broadcasting Antenna or Television Antenna:

i.

Disengage each clamp.

E341907C01
0.167,0.229 0.521,0.49 0.354,0.26 12 false *A 0.167,4.167 0.51,4.427 0.344,0.26 12 false *B
*A w/o Sliding Roof *B w/ Sliding Roof
V100155

Adhesive Tape
V100136

Front



ii.

Remove the adhesive tape from the roof headlining assembly.



c.

Remove the No. 2 antenna cord sub-assembly from the roof headlining assembly.


Hide 86101R 10.REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY

a.

w/ Digital Audio Broadcasting Antenna or Television Antenna:

i.
E341881

Disconnect the connector.


ii.

Disengage the clamp and remove the No. 5 antenna cord sub-assembly.



Hide 86101D 11.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY

a.
E341901

Disconnect the connector.


b.

Disengage the claw.


c.

Disengage the 6 clamps and remove the No. 3 antenna cord sub-assembly.


Hide 64790B 12.REMOVE BACK DOOR UPPER TRIM PANEL ASSEMBLY

Hide 67937B 13.REMOVE BACK DOOR SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR>DISASSEMBLY


Hide 86101Q 14.REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY

a.
E341910

Disconnect the connector.


b.

Disconnect the washer hose.

HINT:

Use a container to collect the windshield washer fluid.



c.

Disengage the 3 clamps.


d.
E341912

Disconnect the connector.


e.

Disconnect the washer hose.

HINT:

Use a container to collect the windshield washer fluid.



f.

Disengage the clamp.


g.
E341914

Disengage the 2 grommets and remove the No. 4 antenna cord sub-assembly.