Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0244228 LIGHTING SYSTEM C

LIGHTING (EXT)  LIGHTING SYSTEM  B243D  Left Low Beam Fan Malfunction  B243E  Right Low Beam Fan Malfunction  


DESCRIPTION

A DTC is stored when a malfunction of the No. 1 headlight fan occurs and the low beam headlight is dim. The No. 1 headlight ECU sub-assembly LH stores DTC B243D or B243E.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B243D Left Low Beam Fan Malfunction Malfunction of headlight fan occurs and low beam headlight LH is dim
·

Headlight unit LH

·

Headlight unit assembly LH (headlight fan LH)

·

No. 1 headlight ECU sub-assembly LH


-
B243E Right Low Beam Fan Malfunction Malfunction of headlight fan occurs and low beam headlight RH is dim
·

Headlight unit RH

·

Headlight unit assembly RH (headlight fan RH)

·

No. 1 headlight ECU sub-assembly RH


-

WIRING DIAGRAM

E335162E19
0.094,3.302 2.458,3.635 2.365,0.333 10 false No. 1 Headlight ECU Sub-assembly 4.594,2.417 6.771,2.625 2.177,0.208 10 false Headlight Unit 5.719,1.51 6.677,1.729 0.958,0.219 10 false Headlight Fan 1.552,1.219 3.729,1.427 2.177,0.208 10 false 6 1.51,1.438 3.688,1.646 2.177,0.208 10 false 15 1.51,1.656 3.688,1.865 2.177,0.208 10 false 14 4.375,1.219 4.688,1.417 0.313,0.198 10 false 12 4.438,1.667 4.594,1.865 0.156,0.198 10 false 4 4.375,1.438 4.625,1.635 0.25,0.198 10 false 11 0.104,3.146 0.292,3.313 0.188,0.167 10 false B 4.604,2.25 4.76,2.448 0.156,0.198 10 false C 3.115,2.938 4.677,3.188 1.563,0.25 10 false Headlight Unit Assembly 1.063,1.313 1.49,1.552 0.427,0.24 10 false FANB 1.063,1.542 1.49,1.781 0.427,0.24 10 false FANP 1.063,1.76 1.49,2 0.427,0.24 10 false FANG

CAUTION / NOTICE / HINT

NOTICE:

If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION


PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Clear DTCs
50002 361

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Turn the power switch on (IG).


b.

Operate the light control switch to turn on the low beam headlights and wait 2 minutes.


c.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Trouble Codes
50001 361
OK:

DTC B243D and B243E are not output.



Result:
Result Proceed to
OK A
NG (DTC B243D is output) B
NG (DTC B243E is output) C



A

B

3.INSPECT HEADLIGHT UNIT ASSEMBLY LH

C

7.INSPECT HEADLIGHT UNIT ASSEMBLY RH
3.INSPECT HEADLIGHT UNIT ASSEMBLY LH
a.

Remove the headlight assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>REMOVAL


b.

Remove the headlight unit assembly LH from the headlight assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY


c.

Inspect the headlight unit assembly LH.

i.
E337135C35
0.844,0.802 1.146,1 0.302,0.198 0.531,2.438 0.833,2.635 0.302,0.198 1.802,2.865 2.24,2 true 1.531,3.094 1.396,3.26 true 1.688,3.094 1.854,3.25 true 1.156,0.427 1.469,0.583 0.313,0.156 10 false *a 0.917,1.875 1.229,2.031 0.313,0.156 10 false *b 0.646,2.458 0.865,2.656 0.219,0.198 10 false B 0.958,0.823 1.177,1.021 0.219,0.198 10 false C 2.125,1.854 2.573,2.01 0.448,0.156 10 false FANB 1.781,3.26 2.24,3.406 0.458,0.146 10 false FANP 1.167,3.26 1.615,3.417 0.448,0.156 10 false FANG
*a Component without harness connected
(to Headlight Unit LH (Headlight Fan LH))
*b Component without harness connected
(to No. 1 Headlight ECU Sub-assembly LH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B-6 (FANB) - C-12 Always Below 1 Ω
B-15 (FANP) - C-11 Always Below 1 Ω
B-14 (FANG) - C-4 Always Below 1 Ω




Result:
Result
OK
NG



OK

4.REPLACE HEADLIGHT UNIT LH (HEADLIGHT FAN LH)

NG

REPLACE HEADLIGHT UNIT ASSENBLY LH

4.REPLACE HEADLIGHT UNIT LH (HEADLIGHT FAN LH)
a.

Replace the headlight unit LH (headlight fan LH) with a new or known good one.

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY


Result:
Proceed to
NEXT



NEXT

5.CLEAR DTC
5.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Clear DTCs
50002 361

Result:
Proceed to
NEXT



NEXT

6.CHECK FOR DTC
6.CHECK FOR DTC
a.

Turn the power switch on (IG).


b.

Operate the light control switch to turn on the low beam headlights and wait 2 minutes.


c.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Trouble Codes
50001 361
OK:

DTC B243D is not output.



Result:
Proceed to
OK
NG



OK

END (HEADLIGHT UNIT LH (HEADLIGHT FAN LH) WAS DEFECTIVE)

NG

REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH

7.INSPECT HEADLIGHT UNIT ASSEMBLY RH
a.

Remove the headlight assembly RH.

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>REMOVAL


b.

Remove the headlight unit assembly RH from the headlight assembly RH.

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY


c.

Inspect the headlight unit assembly RH.

i.
E337135C35
0.844,0.802 1.146,1 0.302,0.198 0.531,2.438 0.833,2.635 0.302,0.198 1.802,2.865 2.24,2 true 1.531,3.094 1.396,3.26 true 1.688,3.094 1.854,3.25 true 1.156,0.427 1.469,0.583 0.313,0.156 10 false *a 0.917,1.875 1.229,2.031 0.313,0.156 10 false *b 0.646,2.458 0.865,2.656 0.219,0.198 10 false B 0.958,0.823 1.177,1.021 0.219,0.198 10 false C 2.125,1.854 2.573,2.01 0.448,0.156 10 false FANB 1.781,3.26 2.24,3.406 0.458,0.146 10 false FANP 1.167,3.26 1.615,3.417 0.448,0.156 10 false FANG
*a Component without harness connected
(to Headlight Unit RH (Headlight Fan RH))
*b Component without harness connected
(to No. 1 Headlight ECU Sub-assembly RH)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B-6 (FANB) - C-12 Always Below 1 Ω
B-15 (FANP) - C-11 Always Below 1 Ω
B-14 (FANG) - C-4 Always Below 1 Ω




Result:
Result
OK
NG



OK

8.REPLACE HEADLIGHT UNIT RH (HEADLIGHT FAN RH)

NG

REPLACE HEADLIGHT UNIT ASSEMBLY RH

8.REPLACE HEADLIGHT UNIT RH (HEADLIGHT FAN RH)
a.

Replace the headlight unit RH (headlight fan RH) with a new or known good one.

Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>DISASSEMBLY


Result:
Proceed to
NEXT



NEXT

9.CLEAR DTC
9.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Clear DTCs
50002 361

Result:
Proceed to
NEXT



NEXT

10.CHECK FOR DTC
10.CHECK FOR DTC
a.

Turn the power switch on (IG).


b.

Operate the light control switch to turn on the low beam headlights and wait 2 minutes.


c.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Trouble Codes
50001 361
OK:

DTC B243E is not output.



Result:
Proceed to
OK
NG



OK

END (HEADLIGHT UNIT RH (HEADLIGHT FAN RH) WAS DEFECTIVE)

NG

REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY RH