2005-2008 RAV4 · Service Manual BRAKE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2008 from Aug 2008

HINT:
  1. Use these procedures to troubleshoot the Vehicle Stability Control System.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK AND CLEAR DTC*
      NEXT

      4.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B

      B.
      A

      5.SYMPTOM SIMULATION
        NEXT

        6.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*
        1. Use the intelligent tester to check for normal functioning of the CAN communication system.

          1. Perform bus check (communication malfunction DTC).

        2. Result 
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B

        B.
        A

        7.CHECK FOR DTC*
          Result 
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B

        B.
        A

        8.PROBLEM SYMPTOMS TABLE
          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B

        B.
        A

        9.OVERALL ANALYSIS AND TROUBLESHOOTING
        1. Terminals of ECU (Click here)

        2. Data List / Active Test (Click here)

        NEXT

        10.CHECK FOR FLUID LEAKAGE
          NEXT

          11.REPAIR OR REPLACE
            NEXT

            12.CONFIRMATION TEST
              NEXT

              ← SYSTEM DESCRIPTION (from Aug 2008)HOW TO PROCEED WITH TROUBLESHOOTING (Jan 2007 – Jul 2008) →