HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Jan 2007 – Jul 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2008 from Aug 2008
- HINT:
- Use these procedures to troubleshoot the Vehicle Stability Control System.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the Vehicle Stability Control System.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK AND CLEAR DTC* |
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result |
Proceed to |
| Symptom does not occur |
A |
| Symptom occurs |
B |
|
|||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)* |
Use the intelligent tester to check for normal functioning of the CAN communication system.
Perform bus check (communication malfunction DTC).
| Result |
Proceed to |
| DTC is not output |
A |
| DTC is output |
B |
|
|||||
| |||||
| 7.CHECK FOR DTC* |
| Result |
Proceed to |
| DTC is not output |
A |
| DTC is output |
B |
|
|||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Fault is not listed in problem symptoms table |
A |
| Fault is listed in problem symptoms table |
B |
|
|||||
| |||||
| 9.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here)
Data List / Active Test (Click here)
| |||||
| 10.CHECK FOR FLUID LEAKAGE |
| |||||
| 11.REPAIR OR REPLACE |
| |||||
| 12.CONFIRMATION TEST |
| |||||