HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2008 from Aug 2008
- HINT:
- Use these procedures to troubleshoot the vehicle stability control system.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the vehicle stability control system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.CHECK AND CLEAR DTC* |
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
- Result:
Result
Proceed to
Symptom does not occur.
A
Symptom occurs.
B
|
|||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)* |
Using the intelligent tester, check for normal functioning of the CAN communication system.
Perform bus check (communication malfunction DTC).
- Result:
Result
Proceed to
DTC is not output.
A
DTC is output.
B
|
|||||
| |||||
| 7.CHECK FOR DTC* |
- Result:
Result
Proceed to
DTC is not output.
A
DTC is output.
B
|
|||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is not listed in problem symptoms table.
A
Fault is listed in problem symptoms table.
B
|
|||||
| |||||
| 9.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here)
Data List/Active Test (Click here)
| |||||
| 10.CHECK FOR FLUID LEAKAGE |
| |||||
| 11.REPAIR OR REPLACE |
| |||||
| 12.CONFIRMATION TEST |
| |||||