2005-2008 RAV4 · Service Manual BRAKE

C0371 Yaw Rate Sensor (Test Mode DTC)

Diagnostic trouble codes · Vehicles built from Aug 2008

Also covers:

DESCRIPTION

DTCs C0371 and C1279 can be cleared when the yaw rate and deceleration sensor sends a yaw rate and/or deceleration signal or when Test Mode ends. DTCs C0371 and C1279 are output only in Test Mode.
DTC Code
DTC Detection Condition
Trouble Area
C0371
Detected only during Test Mode.
Yaw rate and deceleration sensor
C1279
Detected only during Test Mode.
  1. Sensor installation
  2. Yaw rate and deceleration sensor

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate sensor assembly, perform zero point calibration (Click here).


1. CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION
  1. Check that the yaw rate and deceleration sensor has been installed properly (Click here).

    OK:
    The sensor should be tightened to the specified torque.
    The sensor should not be installed in a tilted position.



NG
INSTALL YAW RATE AND DECELERATION SENSOR CORRECTLY (Click here)
OK


2. INSPECT YAW RATE AND DECELERATION SENSOR (IG TERMINAL)

  1. C156491E32
    Make sure that there is no looseness in the locking part and connecting part of the connectors.

  1. Disconnect the yaw rate and deceleration sensor connector.

  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K25-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG CIRCUIT)
OK


3. INSPECT YAW RATE AND DECELERATION SENSOR (GND TERMINAL)

  1. C156491E33
    Turn the ignition switch off.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K25-1 (GND) - Body ground
    Always
    Below 1 Ω

    NOTICE:
    Check the yaw rate and deceleration sensor signal after replacement (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK

REPLACE YAW RATE SENSOR ASSEMBLY (Click here)


← C0278/11 Open in ABS Solenoid Relay Circuit (+ C0279/12) (Aug 2007 – Jul 2008)C1201 Engine Control System Malfunction (from Aug 2008) →