2005-2008 RAV4 · Service Manual CRUISE CONTROL SYSTEM

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Insect the fuses and relays related to this system before inspecting the suspected areas below.

Cruise control system 
Symptom
Suspected Area
See page
SET not occurring or CANCEL occurring (DTC is normal)
1. Input signal circuit
Click here
2. Vehicle speed sensor circuit
Click here
3. Stop light switch circuit
Click here
4. Park / neutral position switch circuit (U140F)
Click here
4. Park / neutral position switch circuit (U241E)
Click here
5. Clutch switch circuit (M/T)
Click here
6. ECM
-
SET not occurring or CANCEL occurring (DTC is not output)
1. Cruise control switch circuit
Click here
2. ECM
-
Actual vehicle speed deviates above or below the set speed
1. Vehicle speed sensor circuit
Click here
2. ECM
-
Gear shifting occurs frequently between 3rd and O/D when driving on
1. Vehicle speed sensor circuit
Click here
2. ECM
-
Cruise control not canceled, even when brake pedal is depressed
1. Stop light switch circuit
Click here
2. ECM
-
Cruise control not canceled, even when transmission is shifted to N
1. Park / neutral position switch circuit (U140F)
Click here
1. Park / neutral position switch circuit (U241F)
Click here
2. ECM
-
Control switch does not operate (-/SET, +/RES, CANCEL not possible)
1. Cruise control switch circuit
Click here
2. ECM
-
SET possible at 40 km/h (25 mph) or less, or CANCEL does not operate
1. Vehicle speed sensor circuit
Click here
2. ECM
-
Poor response in ACCEL and RESUME modes
1. ECM
-
O/D does not resume, even though road is not uphill
1. Vehicle speed sensor circuit
Click here
2. ECM
-
DTC memory is erased
1. ECM
-
DTC is not output, or is output when it should not be
1. TC and CG terminal circuit
Click here
2. ECM
-
Cruise main indicator light remains illuminated or fails to light up
1. Cruise control switch circuit
Click here
2. Combination meter
Click here
3. ECM
-
← PROBLEM SYMPTOMS TABLE (Nov 2005 – Dec 2006)PROBLEM SYMPTOMS TABLE (from Aug 2007) →