Install the back-up light switch and gasket to the manual transaxle case.
Torque:
40 N*m{
410 kgf*cm
, 30 ft.*lbf
}
Connect the back-up light switch connector.
14.
ADD TRANSAXLE OIL
15.
INSPECT TRANSAXLE OIL
Stop the vehicle in a level place.
Remove the transmission filler plug and the gasket.
Check that the oil level is between 0 to 5 mm (0 to 0.20 in.) from the bottom lip of the filler plug opening. If the result is not as specified, add transmission oil.
Oil grade:
GL-4
Viscosity:
SAE 75W
Standard capacity:
2.1 liters (2.2 US qts, 1.8 Imp. qts)
NOTICE:
Too much or too little oil may cause trouble.
After adjusting the oil level, drive the vehicle and check the oil level again.
Check for oil leakage if the oil level is low.
Install the transmission filler plug and a new gasket.
Torque:
39 N*m{
400 kgf*cm
, 29 ft.*lbf
}
16.
ADD TRANSFER OIL
17.
INSPECT TRANSFER OIL
Remove the transfer case plug No. 2 (for filler) and gasket.
Check that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole. If the result is not as specified, add transfer oil.
Oil grade:
GL-5
Viscosity:
SAE 80W-90
Standard capacity:
0.45 liter (0.48 US qts, 0.40 Imp. qts)
NOTICE:
When adding oil, pour it slowly.
Too much or too little oil will lead to transfer problems.
When the oil level is too low, check for oil leakage.
Install a new gasket into the case plug (for filler) and then tighten the plug.