2005-2008 RAV4 · Service Manual BRAKE

AUTO LSD Indicator Light Remains ON

Circuit diagnosis · Vehicles built from Aug 2008

DESCRIPTION

The AUTO LSD is a system for 2WD vehicles. When the VSC OFF switch is pushed on, the AUTO LSD function is available and the AUTO LSD indicator light illuminates.

HINT:
The AUTO LSD does not operate even if the VSC OFF switch is pressed under the following conditions:
  1. The TRC or VSC system is faulty.
  2. The temperature inside the brake actuator assembly increases and the AUTO LSD operation is suspended.


WIRING DIAGRAM

C194143E04

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

Result:
Result
Proceed to
DTC is not output.
A
DTC is output.
B

OK:
The connector is securely connected.



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BODY GROUND)

  1. C194130E25
    Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A67-30 (CSW) - Body ground
    VSC OFF switch is not pushed
    10 kΩ or higher
    VSC OFF switch is pushed
    Below 1Ω



OK
Go to step 6
NG


4. INSPECT TRACTION CONTROL SWITCH (VSC OFF SWITCH)

  1. C194196E02
    Remove the VSC OFF switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (E) - 9 (+)
    Not pushed
    10 kΩ or higher
    Pushed
    Below 1Ω



NG
REPLACE TRACTION CONTROL SWITCH (VSC OFF SWITCH)
OK


5. CHECK HARNESS AND CONNECTOR (VSC OFF SWITCH - SKID CONTROL ECU/BODY GROUND)
C194149E02
  1. Disconnect the skid control ECU connector.

  1. Disconnect the VSC OFF switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A67-30 (CSW) - E96-9 (+)
    Always
    Below 1 Ω
    A67-30 (CSW) - Body ground
    Always
    10 kΩ or higher
    E96-6 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6. INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Downhill Assist Control Indicator Light does not Come ON (from Aug 2008)AUTO LSD Indicator Light does not Come ON (from Aug 2008) →