TRC OFF Indicator Light Remains ON
Circuit diagnosis · Vehicles built from Aug 2008
DESCRIPTION
The TRC OFF indicator light is located in the combination meter for 4WD vehicles.The skid control ECU is connected to the combination meter via the CAN communication system.
Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls. If TRC control turns off, the TRC OFF indicator light comes on.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform zero point calibration (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
- Result:
Result
Proceed to
DTC is not output.
A
DTC is output.
B
|
|
||||
| A | |
| 2. INSPECT SKID CONTROL ECU CONNECTOR |
Check if the skid control ECU connector is securely connected.
- OK:
- The connector is securely connected.
|
|
||||
| OK | |
| 3. CHECK BATTERY |
Check the battery voltage.
- Standard Voltage:
- 11 to 14 V
- Result:
Result
Proceed to
OK
A
NG
for 2AZ-FE
B
for 2GR-FE
C
|
|
||||
|
|
||||
| A | |
| 4. READ VALUE USING INTELLIGENT TESTER (AUTO LSD SWITCH) |
Check the Data List for proper functioning of the AUTO LSD switch.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Auto LSD Switch
Traction control switch (VSC OFF switch) / ON or OFF
ON: Traction control switch (VSC OFF switch) on
OFF: Traction control switch (VSC OFF switch) off
-
- OK:
- ON (VSC OFF switch is ON) appears on the screen.
|
|
||||
| OK | |
| 5. INSPECT COMBINATION METER ASSEMBLY |
Inspect the combination meter (Click here).
|
|
||||
| OK | ||
| ||
| 6. INSPECT TRACTION CONTROL SWITCH (VSC OFF SWITCH) |
Remove the VSC OFF switch (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
6 (E) - 9 (+)
Switch is not pushed
10 kΩ or higher
Switch is pushed
Below 1 Ω
|
|
||||
| OK | |
| 7. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
A67-30 (CSW) - E96-9 (+)
Always
Below 1 Ω
A67-30 (CSW) - Body ground
Always
10 kΩ or higher
E96-6 (E) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
