DTC P0617 Starter Relay Circuit High |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0617 | All conditions are met (1-trip detection logic): (a) Vehicle speed is more than 20 km/h (12.4 mph). (b) Engine speed is more than 1000 rpm. (c) STA signal is ON. (d) Battery voltage (10.5 V or more) is applied to the TCM for 20 seconds. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
Read the value displayed on the intelligent tester.
Crank the engine.
Read the value displayed on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Starter Signal | Starter signal/ ON or OFF |
| - |
|
| ||||
| OK | |
| 2.CHECK TCM (STA VOLTAGE) |
![]() |
Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B128-10 (STA) - Body ground | Ignition switch ON and shift lever in P or N | Below 2 V |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B128-8 (E1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 3.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Disconnect the park/neutral position switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 (B) - 9 (L) | Shift lever in P | Below 1 Ω |
| 4 (B) - 9 (L) | Shift lever in N | Below 1 Ω |
| 4 (B) - 9 (L) | Shift lever not in P | 10 kΩ or higher |
| 4 (B) - 9 (L) | Shift lever not in N | 10 kΩ or higher |
| 1 (RB) - 9 (L) | Shift lever in P, R, N, D or M | 10 kΩ or higher |
| *1 | Component without harness connected (Park/Neutral Position Switch) |
|
| ||||
| OK | ||
| ||