Home › TRANSMISSION ยท EA64 MANUAL TRANSAXLE › MANUAL TRANSAXLE SYSTEM

MANUAL TRANSAXLE SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Manual transaxle system 
Symptom
Suspected Area
See page
Noise
Oil (Level Low)
Click here
Oil (Wrong)
Click here
Gear (Input shaft) (Worn or damaged)
Click here
Gear (No. 1 output shaft) (Worn or damaged)
Click here
Gear (No. 2 output shaft) (Worn or damaged)
Click here
Bearing (No. 1 output shaft) (Worn or damaged)
Click here
Bearing (No. 2 output shaft) (Worn or damaged)
Click here
Bearing (Differential case) (Worn or damaged)
Click here
Oil leakage
Oil (Level High)
Click here
Gasket (Damaged)
Click here
Oil seal (Worn or damaged)
Click here
Hard or impossible to shift
Control cable (Faulty)
Click here
Shift fork (Worn)
Click here
Synchronizer ring (No. 1 output shaft) (Worn or damaged)
Click here
Synchronizer ring (No. 2 output shaft) (Worn or damaged)
Click here
Shift key spring (No. 1 output shaft) (Worn or damaged)
Click here
Shift key spring (No. 2 output shaft) (Worn or damaged)
Click here
Gear (Input shaft) (Worn or damaged)
Click here
Gear (No. 1 output shaft) (Worn or damaged)
Click here
Gear (No. 2 output shaft) (Worn or damaged)
Click here
Hub sleeve (No. 1 output shaft) (Worn or damaged)
Click here
Hub sleeve (No. 2 output shaft) (Worn or damaged)
Click here
Jumps out of gear
Shift fork (Worn)
Click here
Gear (Input shaft) (Worn or damaged)
Click here
Gear (No. 1 output shaft) (Worn or damaged)
Click here
Gear (No. 2 output shaft) (Worn or damaged)
Click here
Bearing (No. 1 output shaft) (Worn or damaged)
Click here
Bearing (No. 2 output shaft) (Worn or damaged)
Click here
The shift lever does not move (or the shift lever is difficult to move) to the 1st or 2nd position.
Control cable (Adjustment)
Click here
It is possible to move the shift lever to the reverse position without pulling up the slider shaft.
Control cable (Adjustment)
Click here