1.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY
2.DISCONNECT FUEL TUBE SUB-ASSEMBLY
3.REMOVE WIRE HARNESS
4.REMOVE FUEL DELIVERY PIPE
5.DISCONNECT WIRE HARNESS
6.DISCONNECT NO. 2 PCV HOSE
7.REMOVE INTAKE MANIFOLD
8.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the engine oil level dipstick.
Remove the bolt and engine oil level dipstick guide.
Remove the O-ring from the engine oil level dipstick guide.
9.REMOVE MANIFOLD STAY
10.REMOVE NO. 2 MANIFOLD STAY
11.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
12.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
13.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
14.REMOVE COOLER COMPRESSOR ASSEMBLY
15.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
Remove the 4 bolts and No. 1 compressor mounting bracket.
Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the No. 1 compressor mounting bracket.
16.REMOVE WATER BY-PASS HOSE
Slide the clip and disconnect the No. 1 water by-pass hose from the cylinder head sub-assembly.
Slide the clip and disconnect the No. 2 water by-pass hose from the No. 1 water by-pass pipe.
17.REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
18.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
19.REMOVE IGNITION COIL ASSEMBLY