When replacing the injectors (including shuffling the injectors between the cylinders), common rail, intake manifold or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, intake manifold or cylinder head, it is necessary to replace the fuel inlet pipe with a new one.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
26100
3.REMOVE DIESEL THROTTLE BODY ASSEMBLY
4.DRAIN ENGINE OIL
5.DISCONNECT ENGINE WIRE
25625
6.REMOVE EGR VALVE BRACKET
16295
7.REMOVE NO. 7 WATER BY-PASS HOSE
16296
8.DISCONNECT NO. 8 WATER BY-PASS HOSE
25602
9.REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY
25800
10.REMOVE ELECTRIC EGR CONTROL VALVE ASSEMBLY
23804C
11.REMOVE FUEL INLET PIPE SUB-ASSEMBLY
23701
12.REMOVE INJECTION PIPE SUB-ASSEMBLY
23810A
13.REMOVE COMMON RAIL ASSEMBLY
17853B
14.REMOVE INTAKE MANIFOLD INSULATOR
11452
15.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
89421C
16.REMOVE DIESEL TURBO PRESSURE SENSOR
23265
17.REMOVE NO. 1 GAS FILTER
17696
18.REMOVE GAS FILTER BRACKET
12631A
19.REMOVE ENGINE COVER BRACKET
17112
20.REMOVE NO. 2 INTAKE MANIFOLD
25770A
21.DISCONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY
17111
22.REMOVE INTAKE MANIFOLD
16261
23.REMOVE WATER BY-PASS HOSE
Slide the 2 clamps and remove the water by-pass hose from the oil cooler assembly and water outlet.
15710
24.REMOVE OIL COOLER ASSEMBLY
Remove the 5 bolts and oil cooler assembly.
Remove the 3 gaskets from the No. 1 oil cooler bracket.